Factory Default Settings - Viking K-2000-DVA Product Manual

A. Entering the Programming Mode
1. Local
Step 1. Move the PROG/NORM switch to PROG and plug an analog phone into the TELCO jack.
Step 2. After taking the phone off hook, wait for two beeps.
Step 3. Program as shown in sections B-T.
Step 4. To exit programming, hang-up. Set the PROG/NORM switch to NORM.
2. Remote
Make sure the PROG/NORM switch is set to the NORM position and that there is a CO line or
Step 1.
analog PABX/KSU extension in the TELCO jack.
Call into the K-2000-DVA on that line or extension. The unit will answer after the set ring delay
Step 2.
(see Programming section G) and a single beep should be heard.
Enter a Q and the six-digit security code (factory default is 845464). If the correct code is entered,
two beeps should be heard.
Note: The security code must be entered within 20 seconds otherwise the K-2000-DVA will time
Step 3.
out and hang up. When in programming, if 20 seconds elapse without Touch Tones being
entered or a message being recorded, the K-2000-DVA will automatically exit programming and
hang up.
Step 4. Program as shown in sections B-T.
To exit programming, hang-up. After the 20 second timeout has elapsed, the K-2000-DVA will
Step 5. be ready for normal operation. Alternatively, dial ##7 and the K-2000-DVA will immediately be
ready for normal operation
Note: Correct programming entries are implemented and then acknowledged by two beeps. Incorrect
programming entries are discarded and receive three beeps to indicate an error.
B. Factory Default Settings
Security Code
Access Code
Alarm Dialer Mode
Store Caster Mode
Phone Numbers
Messages
Ring Delay
Ringback Limit
Pager Number
Call Progress Detection
Dialing Speed
Alarm Input Configuration
Lap Counter
Message Repeat Counter
Qualifier Timer
Resume Timer
Hookswitch Flash Before Dialing
4
Programming
845464 (V-I-K-I-N-G) (see section D
123456 (see section F)
Enabled (see section E)
Disabled (see section E)
Not Programmed (see section O)
Not Recorded (see section R)
1 (see section G)
6 (see section H)
Not Programmed (see section P)
Enabled (see section J)
Normal (see section I)
N/O (Enabled) Momentary (see section K)
1 (see section L)
2 (see section L)
0 - disabled (see section M)
0 - disabled (see section N)
Disabled (see section Q)