Ttaching The Ccessories; Operating The Waterpark - Buckets Of Fun RPBOF User Manual

ATTACHING THE ACCESSORIES
IMPORT NT: Before attaching accessories, it is recommended to place the
waterpark in the location it will be used.
1. Insert batteries (NOT included) into the Bubble Maker. ttach the Bubble
Maker (CC) to the center of the top lateral pipe, across from the water and
sand tables using Straps ( ) as shown (Fig. 12).
2. Secure the Funnel to the front upright.
IMPORT NT: Do NOT screw into any pipe that has a union or is designated
as a "feed line". Look at the location of the funnel before screwing into the pipe.
(1) Funnel Hose
(1) C Funnel
(2) BB Self Tapping Screws
Using a Phillips head screw driver, attach the funnel just above the coupling
of the front upright, opposite of the water and sand tables as shown (Fig. 13).
-
Insert the Funnel Hose ( ) into the bottom of the Funnel (C) and then wrap
the hose twice around the upright. Secure the hose to the bottom of the
upright with a Self Tapping Screw (BB) by screwing through the inside
portion of the hose only as shown (Fig. 14).
Fig. 12
Fig. 13
NOTE: Scissors may be necessary to cut the hose to the desired length.
3. Insert the (2) Water and Sand Basins (E) into the table frames (Fig. 15).
IMPORT NT: Tap all connections together prior to installing bins. Use a
rubber mallet and tap front to back and side to side, ensuring the pipes are
all the way inside the fittings.

OPERATING THE WATERPARK

WARNING: Do NOT allow children to use the waterpark unless there is proper
supervision.
WARNING: NEVER leave children unattended while the waterpark is in use.
WARNING: Do NOT leave water in the bucket or basins; empty after use.
WARNING: Ensure all fittings are secure before operating the waterpark.
WARNING: Surfaces may become slippery, ensure proper precautions are taken
IMPORT NT: Ensure the waterpark is in the location where it will be used. Do
NOT attempt to move the waterpark when it is filled with water or has water/sand
in the basins.
6
Fig. 14
Fig. 15