Inner Range Integriti Prisma Keypad User Manual page 13

Integriti. Integriti. Integriti.
Integriti. Integriti.
AREA LISTS. Allows you to turn OFF all the Areas in the selected List, that you are
allowed to control, with a single operation.
i.e. You can select any Area List in the system. However, only Areas that are in the
Area List selected and are also Areas that you have permission to turn off (disarm),
will be turned Off.
24 HOUR. Allows the Installer, or a User with the appropriate level of authority, to
turn the 24Hr part of an Area Off, so that maintenance or changes can be performed
on equipment or devices (detectors etc.) in the system. The 24Hr part of an Area
continuously monitors the equipment and inputs for faults or deliberate interference
and activates "Tamper" alarms when these conditions occur.
Note that this operation is normally restricted to the Installer &/or Owner only. Most
Users in the system will NOT have access to this operation.
Note: When the 24 Hour monitoring is turned Off in an Area, it will automatically
be turned back On again when the Area is turned ON to ensure that Tamper
monitoring is not compromised. If the Area was already Off when the 24Hr
monitoring was turned Off, the Area must be turned back on again before 24Hr
monitoring will be re-enabled.
Colour Graphic Terminal User Manual.
DISPLAY MODE.
If you have permission to turn ON &/or OFF:
- More than one Area.
- The 24 Hour (Tamper) part of an Area.
The Display mode can be toggled between
AREAS, AREA LISTS and 24 HOUR, by
pressing the right hand FUNCTION key.
Once in the selected mode, Area/Area List
selection and control is the same as described
previously. Please read additional information
below:
13