Summit SINC2B120 Use And Care Manual page 17

Power sharing
The fans keep running for one
minute after the unit has been
switched off
"E0 appears in the digital display "
"E1 appears in the digital display "
"E2 appears in the digital display "
"E3 appears in the digital display "
"E7 appears in the digital display "
"E8 appears in the digital display "
"E9 appears in the digital display "
"EE" appears in the digital display
If your unit is still not functioning properly, call SUMMIT toll-free at 800-932-4267
to speak with a representative.
SUMMIT APPLIANCE
When two heating zones are
turned on, will create a total max
8 setting
The electronics are cooling down
IGBT overheating
No cookware found or improper
placement of cookware on the
cooking zone
Supplied voltage to cooktop is
too low
Supplied voltage to cooktop is
too high
NTC1 Break off
NTC1 Short circuit
NTC2 Break off
NTC2 Short circuit
16
See POWER SHARING
This is a normal occurrence
Turn off unit to allow IGBT to
cool. Restart unit
Make sure that the cookware is
centered on the cooking zone,
and that it is also induction
compatible. See COMPATIBLE
COOKWARE
If the voltage of the power
supplied to the cooktop is too
low, it cannot operate properly
and will show this error code.
This may be caused by reduced
voltage being supplied to the
house circuit. If connections are
correct and the supplied voltage
returns to normal, the code will
disappear
If the voltage of the power
supplied to the cooktop is too
high, it cannot operate properly
and will show this error code.
This may be caused by
increased voltage being
supplied to the house circuit. If
the connections are correct and
the supplied voltage returns to
normal, the code will disappear
Turn the cooktop OFF; then pull
plug out for about 30 seconds.
Then re-insert the plug and turn
the cooktop on using the
POWER pad. If the error
message is still displayed, call
for service
Felix Storch, Inc.