Operating The Headlights; Using The Blade Control (Pto); Setting The Height Of Cut; Starting The Engine - Toro DH 210 Operator's Manual

1. Adjustment knobs
2. Move the seat to the desired position and tighten
the knobs.

Operating the Headlights

The headlights are an integral function of the ignition
switch. Turn the ignition key clockwise to the Lights
position.
Using the Blade Control
(PTO)
The blade control (PTO) knob engages and
disengages power to the blades.
Engaging the Blades
1. Depress the brake pedal to stop the machine.
2. Pull the blade control (PTO) knob out to the
Engaged position
Disengaging the Blades
1. Depress the brake pedal to stop the machine.
2. Push the blade control (PTO) knob into the
Disengaged position

Setting the Height of Cut

Use the height-of-cut lever to raise and lower
the mower to the desired cutting height. You can
set the cutting height to 7 different positions from
approximately 30 to 80 mm (1-1/4 to 3-1.8 inches).
Figure 6
(Figure 4).
(Figure 4).
Important:
You must set the height-of-cut lever
to the highest position (7) when you transport the
machine off the lawn to prevent damaging the
blades.
1. Push and hold in the button on the height-of-cut
lever (Figure
g008253
1. Height-of-cut lever
2. Shift the height-of-cut lever to the desired
position.
3. Release the button.

Starting the Engine

1. Open the fuel shut-off valve located between the
fuel tank and the engine
1. Fuel shut-off valve
Note:
The valve handle should align with the
fuel hose.
2. Sit down on the seat.
3. Ensure the traction control pedals are in the
Neutral position.
13
7).
Figure 7
(Figure 8).
Figure 8
g017870
g008258