Replacing The Fuel Filter; Electrical System Maintenance; Replacing The Headlight Bulbs - Toro DH 210 Operator's Manual

9. Open the fuel shut-off valve and allow the fuel to
drain into an approved fuel container or a drain
pan.
Note:
Now is the best time to install a new fuel
filter because the fuel tank is empty.
10. Install the fuel line onto the fuel filter.
11. Slide the hose clamp close to the fuel filter to
secure the fuel line

Replacing the Fuel Filter

Service Interval: Every 100 hours/Yearly (whichever
comes first)
The best time to replace the fuel filter
when the fuel tank is empty. Never install a dirty fuel
filter after it has been removed from the fuel line.
1. Park the machine on a level surface.
2. Disengage the blades (PTO).
3. Set the parking brake.
4. Stop the engine and wait for all moving parts to
stop.
5. Remove the ignition key.
6. Close the fuel shut-off valve
Figure 30
1. Fuel shut-off valve
7. Squeeze the ends of the hose clamps together
and slide them away from the old fuel filter
(Figure 30).
8. Remove the old fuel filter from the fuel line.
9. Install a new fuel filter and move the hose
clamps close to it.
10. Open the fuel shut-off valve.
(Figure 29).
(Figure 29) is
(Figure 30).
Electrical System
Maintenance
Replacing the Headlight
Bulbs
1. Disengage the blades (PTO).
2. Set the parking brake.
3. Stop the engine and wait for all moving parts to
stop.
4. Remove the ignition key.
5. Open the hood.
6. Pull out the bulb socket
1. Bulb
7. Bend the wire tabs in the metal sleeve (that hold
the bulb in place) out of the way; refer to
32.
g008278
1. Bulb
8. Remove the old light bulb.
9. Install a new light bulb.
27
(Figure 31).
Figure 31
2. Bulb socket
Figure 32
2. Wire tabs (3)
g017879
Figure
g017880