Table of Contents
Advertisement
1. Adjustment knobs
2. Move the seat to the desired position and tighten
the knobs.
Operating the Headlights
The headlights are an integral function of the ignition
switch. Turn the ignition key clockwise to the Lights
position.
Using the Blade Control (PTO)
The blade control (PTO) knob engages and disengages
power to the blades.
Engaging the Blades
1. Depress the brake pedal to stop the machine.
2. Pull the blade control (PTO) knob out to the
Engaged position (Figure 4).
Disengaging the Blades
1. Depress the brake pedal to stop the machine.
2. Push the blade control (PTO) knob into the
Disengaged position (Figure 4).
Setting the Height of Cut
Use the height-of-cut lever to raise and lower the mower
to the desired cutting height. You can set the cutting
height to 7 different positions from approximately 30
to 80 mm (1-1/4 to 3-1.8 inches).
Important: You must set the height-of-cut lever
to the highest position (7) when you transport the
Figure 6
machine off the lawn to prevent damaging the
blades.
1. Push and hold in the button on the height-of-cut
lever (Figure 7).
1
1. Height-of-cut lever
2. Shift the height-of-cut lever to the desired position.
3. Release the button.
Starting the Engine
1. Open the fuel shut-off valve located between the
fuel tank and the engine (Figure 8).
1. Fuel shut-off valve
Note: The valve handle should align with the fuel
hose.
2. Sit down on the seat.
3. Set the parking brake; refer to Setting the Parking
Brake.
4. Disengage the blades (PTO); refer to Figure 4.
12
G017870
Figure 7
Figure 8
Advertisement
Table of Contents
