Recording; Basic Recording Operation; Start Recording - Roland R-07 Reference Manual

Recording

Basic Recording Operation

Recall settings for specific
purposes
Specify the recording quality
Record
1
Switch on the R-07's power (p. 6).
2
Recall the settings that are most appropriate for
your specific recording situation (p. 13).
3
Specify the audio quality of the recording (p. 14).
4
Adjust the recording level (p. 17).
5

Start recording.

If the REC/PLAY indicator is unlit, press [ ] to make it blink red,
putting the unit in recording-standby mode.
In recording-standby mode, press [ ] or [
indicator is lit red, and recording starts.
MEMO
After recording starts, you can set the [POWER] switch to the
HOLD position so that accidental button presses do not stop
the recording or change the input level.
NOTE
5 The built-in mics cannot be used if a mic or other device is
connected to the MIC/AUX IN jack. If you want to use the
built-in mics, do not connect anything to the MIC/AUX IN
jack.
5 The recording level will change if you operate the INPUT [+]
[–] buttons in recording-standby mode or during recording.
Take care that you don't inadvertently operate the INPUT [+]
[–] buttons.
5 You can't turn off the power during recording. You must stop
recording before you can turn off the power.
6
Press [ ] to stop recording.
The REC/PLAY indicator will go out.
12
Adjusting the Input Level
Stop
]; the REC/PLAY
The display will show the file that was recorded (p. 5).
MEMO
5 To pause, press [
recording, press [
5 A file name such as R07_0001.WAV will be created
automatically. The 0001 portion is assigned as a number that
is one greater than the largest number of the existing files.
5 If the Recorder parameter File Name is set to "Date, " the date
and time of recording will be the file name. For details, refer
to "File Name" (p. 39).
7
Press [ ] to play back the recorded file.
For details, refer to "Basic Playback Operation" (p. 22).
]. To disengage pause and resume
] once again.