Heating Operation - Panasonic CU-4E27PBE Service Manual

11.2 Heating Operation

11.2.1 Outdoor fan control

When heating operation is enabled, based on outdoor ambient temperature, fan motor control will be adjusted
according to figure below for Heating overload control:
11.2.2 Heating Room Temp Sampling Control

To improve the judgment accuracy, indoor room temperature sampling starts when any indoor unit has stopped
capability supplied (heating thermo-off) during heating operation with compressor ON, outdoor unit will send
signal to all thermo-off indoor units to ON fan motor and get room temperature sample.

To prevent discharge temperature drop at indoor units which is ON when sampling the room temperature of
heating thermo-off units, the compressor frequency is increased accordingly.

However, if indoor room temperature is much higher compare to remote control setting temperature, before
thermo-off, sampling of corresponding indoor unit will be cancelled.
11.2.3 Powerful Operation 2

During cooling / heating operation, this control is to provide fast cooling / heating operation compare to normal
operation.

Operation start if all condition below are complied:
Powerful operation ON for indoor unit.
o
Not under Annual Cooling control.
o

Operation content:
Outdoor fan speed will adjust automatically.
o
Compressor frequency will adjust automatically.
o

Operation stop when comply either one of the follow conditions:
When the powerful operation is OFF for all indoor units.
o
When annual cooling control activated.
o
AMP Air Conditioning
35
www.ampair.co.uk | sales@ampair.co.uk