OWC THUNDERBLADE User Manual page 6

3. Next you will be asked if it is OK to erase the existing volume on the OWC
ThunderBlade, in order to set up your new SSD for use with a Windows PC.
When you are ready and sure that any relevant data has been backed up, click
Erase and Set Up for Windows.
4. After a moment, the ThunderBlade should be formatted for PC and a dialog will
confirm that it is ready to be opened and used. You can either click the 'Open
ThunderBlade...' button or click Close and then navigate to the ThunderBlade
in your Windows Explorer. Note: the dialog below shows the drive with a letter
designation of 'D,' however this can vary from system to system, depending on
available drive letters.
OWC ThunderBlade
4
Mac & PC Setup