Download Print this page

Axxess OESWC-CLASS2H Installation Instructions Manual

03-up class2 harness for oe rf/stk

Advertisement

Quick Links

INSTALLATION INSTRUCTIONS FOR PART OESWC-CLASS2H
OESWC-CLASS2H
03-UP CLASS2 HARNESS FOR OE RF/STK
The OESWC-CLASS2H is to be used with either the OESWC-STK
or OESWC-RF. Please refer to instructions provided with
OESWC-STK or OESWC-RF for mounting instructions.
1-800-221-0932
axxessinterface.com
© COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION

Advertisement

loading

Summary of Contents for Axxess OESWC-CLASS2H

  • Page 1 INSTALLATION INSTRUCTIONS FOR PART OESWC-CLASS2H OESWC-CLASS2H 03-UP CLASS2 HARNESS FOR OE RF/STK The OESWC-CLASS2H is to be used with either the OESWC-STK or OESWC-RF. Please refer to instructions provided with OESWC-STK or OESWC-RF for mounting instructions. 1-800-221-0932 axxessinterface.com © COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION...
  • Page 2 Wiring the OESWC interface 1. Connect the red wire to 12 volt accessory 2. Connect the Black wire to ground (you may use the same ground that you use for the aftermarket radio) Setting up the OESWC transmitter 1. Press the Red and Green buttons simultaneously for 5 seconds, and then press volume up for two seconds.
  • Page 3 5. This is the end of the auto detection stage. If the OESWC TRANSMITTER detected the vehicles radio successfully the led will light up solid red. 6. Make sure the steering wheel control buttons function correctly in the vehicle and enjoy your radio. So what if the led does not light up solid red? Check out troubleshooting section below.
  • Page 4 STALK Wiring of ASWCSTALK and interface 1. Connect the BLACK wires of the ASWCSTALK and the BLACK wire of the interface to ground. You may use the same ground point that is used for the radio. 2. Connect the GREEN/ORANGE and BLACK/GREEN wires of the ASWCSTALK to the corresponding wires on the interface.
  • Page 5 If the ASWCSTALK is mounted on the right side of the steering column follow the instructions below. (Auto-detect must be done first) 1. Turn the ignition on 2. Press the MODE on the ASWCSTALK for 10 seconds 3. Then press volume up for 2 seconds 4.
  • Page 6 1. Volume up 2. Volume down 3. Seek up 4. Seek down 5. Mode (source) 1. Volume up 2. Volume down 3. Seek up 4. Seek down 5. Mode (source)
  • Page 7 NOTES...
  • Page 8 INSTALLATION INSTRUCTIONS FOR PART OESWC-CLASS2H 1-800-221-0932 © COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION NOWLEDGE IS Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics school in our industry. Log onto www.installerinstitute.com or call 800-354-6782 for more information and take steps toward a better tomorrow.