Planet FGSW-2620VM Series Quick Installation Manual page 2

5. Logon to the Console
(FGSW-2620PVM / FGSW-2612PVM)
Once the terminal has connected to the device, power on
the FGSW-2620PVM, the terminal will display that it is
running testing procedures.
Then, the following message asks the login user name and
password. The factory default password as following and the
login screen in Figure 5-1 appears.
Username: admin
Password: admin
Figure 5-1 FGSW-2620PVM Console Login screen
- 9 -
1. For security reason, please change and
memorize the new password after this first
setup.
Note 2. Only accept command in lowercase letter
under console interface.
- 10 -
6. While IP Address be changed or
forgotten admin password –
To reset the IP address to the default IP Address
"192.168.0.100" and the user name / password to factory
default mode (default user name and password is admin).
Press the hardware reset button at the front panel about
5 seconds. After the device is rebooted, you can login the
management Web interface within the same subnet of
192.168.0.xx and default user name / password. Be noted,
all the previous setup will disappeared after factory reset.
Hardware Reset
- 11 -
7. Customer Support
Thank you for purchase PLANET products. You can browse
our online FAQ resource at the PLANET Web site first to
check if it could solve you issue. If you need more support
information, please contact PLANET switch support team.
PLANET online FAQ :
http://www.planet.com.tw/en/support/faq.php?type=1
Switch support team mail address :
support_switch@planet.com.tw
Copyright © PLANET Technology Corp. 2009.
Contents subject to revision without prior notice.
PLANET is a registered trademark of PLANET Technology
Corp. All other trademarks belong to their respective
owners.
- 12 - - 13 - - 14 -