Table of Contents
Advertisement
Oct.2004(Jul.2006)
CHECKING THE VERSION
NUMBER
tools Required
• One pair of headphones
• Two BOSS FS-5U foot switches (sold separately)
• Two foot switch connector cables (phone-phone)
1.
Set up the CUBE-100 BASS as described below.
[Connections]
Connect an FS-5U foot switch to each of the two FOOT SW jacks (EFX,
DELAY/REVERB).
Set the FS-5U polarity switches to the jack side. Do not connect anything to any
of the other jacks.
[Panel Settings]
POWER SW:
OFF
PAD SW:
OFF
SHAPE SW:
OFF
COSM AMPLIFIER TYPE SW: SUPER FLAT
All VRs:
Minimum
The version number will not be displayed unless the connections and panel
settings are correct.
2.
Press down on the foot switch FS-5U connected to the DELAY/REVERB
jack while turning on the power.
3.
While continuing to press the FS-5U connected to the DELAY/REVERB
jack, press the FS-5U connected to the EFX jack twice, within four
seconds. After all the LEDs turn on, they begin to flash.
4.
Press the FS-5U connected to the DELAY/REVERB jack again.
This switches the CUBE-100 BASS to version display status.
Check the version according to which of the POWER LED, the
COMPRESSION LED, and the SHAPE LED are lit or off.
fig.CB-100_version.eps
POWER LED
COMPRESSION LED
LED
1.00
1.01
POWER
o
x
COMPRESSION
x
o
SHAPE
x
x
o: Lit
x: Off
If the EFX LED or DELAY/REVERB LED are lit at this time, the CPU or DSP
self-diagnosis is failure (NG).
The version is still indicated even when this occurs.
5.
Turn off the power.
12
SHAPE LED
1.02
1.03
1.04
1.05
1.06
o
x
o
x
o
o
x
x
o
o
x
o
o
o
o
TEST MODE
tools Required
• One pair of headphones
• Two BOSS FS-5U foot switches (sold separately)
• Two foot switch connector cables (phone-phone)
Entering Test Mode
1.
Set up the CUBE-100 BASS as described below.
[Connections]
Connect an FS-5U foot switch to each of the two FOOT SW jacks (EFX,
DELAY/REVERB).
Set the FS-5U polarity switches to the jack side. Do not connect anything to any
of the other jacks.
[Panel Settings]
POWER SW:
OFF
PAD SW:
OFF
SHAPE SW:
OFF
COSM AMPLIFIER TYPE SW: SUPER FLAT
All VRs:
Minimum
The CUBE-100 BASS will not enter Test mode unless the connections and
panel settings are correct.
2.
Press down on the foot switch FS-5U connected to the DELAY/REVERB
jack while turning on the power.
3.
While continuing to press the FS-5U connected to the DELAY/REVERB
jack, press the FS-5U connected to the EFX jack twice, within four
seconds. After all the LEDs turn on, they begin to flash.
Exiting Test Mode
Turn off the power to exit the Test mode.
Skipping
Tests cannot be skipped in Test mode.
Test Items
1. Version Display/CPU and DSP Test
(determined automatically)
Press the FS-5U connected to the DELAY/REVERB jack.
The version is indicated by on/off status of the POWER LED, the
COMPRESSION LED, and the SHAPE LED.
CB-100
Hide quick links:
Advertisement
Table of Contents
