Troubleshooting (Navigation) - Kia LAN-8660EK Owner's Manual

Troubleshooting (Navigation)

Cannot identify the current location. (GPS not receiving)
GPS cannot be used indoors and must be connected to a power source with ACC to a
vehicle in a location where the sky can be seen well.
When initially connecting the GPS, it usually takes about 10 minutes to be normally
operating, but the connection speed can differ depending on the weather condition, and
surrounding obstacles.
If the GPS connection is unstable for a long period of time, try the following:
• Check if the power is connected to the product.
• Check if the back of the GPS product is in a location where the sky can be seen well.
• If there are high buildings or if you are under a tree, move to a location where there
aren't any obstacles.
• Check the GPS receiving condition from the GPS menu.
• Please make sure it is changed to the start point for simulation at MENU > Route > New
Start Point.
Cannot hear the voice guide
You can hear the voice guide when you select the "SETUP>Volume".
But during actual driving, the voice guide is provided.
If the volume is too low, adjust the volume on the left side.
If the volume is mute, press the AV OFF button on the right side.
There is a difference between the driving road and the road on the
map in the product
Even though GPS is usually very accurate, it has an error range.
When the GPS receiver is installed, there can be an error of about 5 to 15m. But for newly
constructed roads, the problem could be from the data update to the map.
Cannot see the map
This is when you cannot see the map even when you have executed the navigation menu.
This happens when the data within the memory is damaged. Delete all the data within the
memory and newly install the data.
If the issue persists after installation, contact the A/S center.
Map data and dangerous area information are not newly updated
You must periodically update the map data.
Inquire to Shop that customer who want to buy Europe Map buys
vechicles
61