Reebok RBBE11700 User Manual page 7

3. Attach the Bench Leg (1) to the Bench Frame (5)
with two Bench Joint Plates (18), four 3/8Ó x 3Ó
Bolts (21), and four 3/8Ó Nylon Locknuts (11).
Note: Tighten all the M10 Nylon Locknuts (11)
used in steps 1-3.
4. Press two 1Ó x 1 1/2Ó Inner Caps (28) into each
Backrest Tube (27). Press two 1Ó x 1 1/2Ó Inner
Caps into the Backrest Adjustment Bracket (35).
Lubricate a 3/8Ó x 7 1/2Ó Bolt (22). Attach the
Backrest Tubes (27) to the welded tube on the
Backrest Adjustment Bracket (35) with the Bolt and
a 3/8Ó Nylon Locknut (11). Make sure that the
Backrest Tubes are turned as shown. The indi-
cated holes are not centered in the Backrest
Tubes but are closer to one side. Turn the
Backrest Tubes so the holes are closer to the
floor. Do not overtighten the Nylon Locknut; the
Backrest Tubes must pivot easily.
5. Lubricate a 3/8Ó x 7 1/2Ó Bolt (22). Attach the
Backrest Tubes (27) to the welded tube on the
Bench Frame (5) with the Bolt and a 3/8Ó Nylon
Locknut (11). Note: Do not overtighten the Nylon
Locknut; the Backrest Tubes must pivot easily.
6. Attach the Backrest (15) to the Backrest Tubes (27)
with four 1/4Ó x 2Ó Screws (4) and four 1/4Ó Washers
(30).
3
21
4
Lubricate
22
Holes
28
Welded
Tube
5
Lubricate
22
27
Welded Tube
5
6
15
7
18
5
18
1
11
28
27
11
35
28
11
27
30
4