Table of Contents
Advertisement
4408
3.2
Configuring an 8x1 switcher
The simplest configuration is a single 8x1 module without expansion.
Control of the switcher may be from either a simple control panel or in binary form
from a more complex control system such as a computer. PL3 is used to establish the
method of crosspoint control. All other jumpers positions can be ignored since they
only affect expansion.
PL3 Crosspoint control mode
Position
BUTTON
BIN
Configuration changes are accomplished by pulling the jumper (the shaded area
above) from its current position on the header pins and moving it to the alternate
position desired. The jumper must make electrical contact with at least two pins.
Technical Manual
Digital Audio 8x1 Switch
Function
Crosspoint selection using a button panel
Crosspoint selection using binary control
13
Advertisement
Table of Contents
