Mounting The Router; Mounting On A Table; Mounting On A Wall - Cisco 836 Hardware Installation Manual

Chapter 2 Installation

Mounting the Router

Mounting on a Table

Caution

Mounting on a Wall

Caution
78-15281-02
You can mount the router on one of the following surfaces:
• Table or other horizontal surface
Wall or other vertical surface
•
Place the router firmly on a table, and perform the tasks identified in the
"Installing the Router" section on page
Do not cover or obstruct the router vents, which are located on the sides of the
router. If the vents are covered or obstructed, overheating could occur and cause
damage to the router.
You can mount the router on a wall or other vertical surface by using the molded
mounting brackets on the bottom of the router and two number-six, 3/4-in.
(M3.5 x 20 mm) screws. You must provide the screws. Figure 2-7 shows the
mounting brackets.
If you are mounting the router on drywall, use two hollow-wall anchors (1/8 in.
with 5/16-in. drill bit, or M3 with 8-mm drill bit) to secure the screws. If the
screws are not properly anchored, the strain of the network cable connections
could pull the router from the wall.
Cisco 836 Router and SOHO 96 Router Hardware Installation Guide
Mounting the Router
2-33.
2-43