Overview Of Installation; Flow Of Tasks; Visual Inspection; Setting The Address Switch - Siemens SIMATIC TI505 User Manual

2.1

Overview of Installation

Flow of Tasks

Visual Inspection

Setting the Address
Switch
! WARNING
2-2 Installing the Module
Figure 2-1 shows the organization of the tasks described in this chapter.
Figure 2-1 Flowchart of Installation
If there is any visible damage to the module, contact your Siemens
Industrial Automation, Inc. distributor or sales office. If you need assistance
in contacting your U.S. sales office, call 1–800–964–4114.
Use the address switch to assign the address number to the unit for system
identification. Each unit must have a unique address number. The switch is
labeled 0 through F, hexadecimal. Therefore, a switch number of 5 equals
address 5, and a switch number of E equals address 14. An address of 0 is
valid only with the TI560/TI565 controller.
To minimize the potential risk of injury to personnel or damage to
the system, do not change the unit address switch while the system
is operating. Unpredictable behavior may result.
Set address switch
Secure module to panel
Wire terminal block
Power up