Button Definitions; Manual No. 016-0159-831 I; Chapter 5 Console Programming And Calibration - Raven SCS 450 Installation & Service Manual

Button Definitions

Calibration Buttons
The calibration buttons are used to enter data into the console when calibrating the system. Refer to the table
below for the button names and functions.
Button Name
BOOM CAL
SPEED CAL
METER CAL
VALVE CAL
RATE 1 CAL
RATE 2 CAL
TIME
Function Buttons
The function buttons are used to display the data on a particular aspect of the application. Refer to the table
below for the button names and functions.
Button Name
TOTAL AREA
TOTAL VOLUME
FIELD AREA
FIELD VOLUME
DISTANCE
SPEED
VOL/MIN
AREA/HOUR
DATA MENU
SELF TEST
Manual No. 016-0159-831
Length of the boom. Select the boom number by using the up/down arrow keys.
Determined by speed sensor.
Meter calibration number.
Valve response time
Target application rate.
Target application rate.
24 hour clock (military time).
Displays total area applied. To zero out this figure, press ENTER, 0, then ENTER in this
menu.
Displays total volume applied. To zero out this figure, press ENTER, 0, then ENTER in
this menu.
Displays field area applied. To zero out this figure, press ENTER, 0, then ENTER in this
menu.
Volume applied to the field. To zero out this figure, press ENTER, 0, then ENTER in this
menu.
Displays distance traveled. To zero out this figure, press ENTER, 0, then ENTER in this
menu.
Displays the vehicle's speed.
Displays the volume per minute applied.
Calculates the total area covered per hour at the present speed (not an average).
Used for data logging and variable rate commands.
Displays data after selecting volume rate, speed sensor type, or valve type.
Console Programming and Calibration
Function
Function
27