Advanced Configuration - Johansson 8200 User Manual

HDMI Modulator
When you choosed y
(yes), the screen will
show:
The basic configuration is done. If you want to change any of the above settings, please
repeat the steps as mentioned above, in the "Basic Configuration" part.

Advanced Configuration

In this part we will make the ADVANCED CONFIGURATION of the HDMI Modulator. This will
however not be needed in most installation.
The advanced configuration includes the following screens:
Advanced RF Output,
-
 Setup RF Output (with 4 adjustable parameters)
 Rtrv status (read out of 9 parameters)
 Advanced (with 2 adjustable parameters)
 Back
Advanced Video,
-
 Rtrv Status (read out of 4 parameters)
 Back
Advanced Audio,
-
 Rtrv Status (read out of 1 parameter)
 Back
Advanced Stream,
-
 Set service ID
 Set PID
 Set NIT
 Set PDS
 Set TS ID
 Rtrv Status (read out of 13 parameters)
 Back
Advanced system,
-
 Rtrv Inventory
 Reboot System
 Reset to Default
 Back
Advanced Exit,
-
(REF. 8200)
Followed by the screen as mentioned below:
Note: the frequency shown here can be different of the
frequency of your choice.
9