Operation - RedMax G621AVS Owner's/Operator's Manual

7. Operation

F6
F7
F8
F9
F10
10 
WARNING
It is very dangerous to run a chainsaw that
mounts broken parts or lacks any parts.
Before starting engine, make sure that all the
parts including bar and chain are installed
properly.
■ STARTING ENGINE
1. Fill fuel and chain oil tanks respectively, and
tighten the caps securely. (F6)
2. Put the switch to "I" position. (F7)
3. While holding the throttle lever together with the
throttle interlock, push in the side latch and
release the throttle lever to hold it at the starting
position. (F8)
4. Pull out the choke knob to the closed position.
(F9)
(1) Chain oil
(3) Switch
(5) Throttle interlock
(7) Choke knob
NOTE
When restarting immediately after stopping the
engine, leave the choke knob at the open position.
5. While holding the saw unit securely on the
ground, pull the starter rope vigorously. (F10)
WARNING
Do not start the engine while hanging the chain
saw with a hand. The saw chain may touch
your body. It's very dangerous.
6. When engine has ignited first, push in the choke
knob and pull the starter again to start the
engine.
7. Allow the engine to warm up with the throttle
lever pulled slightly.
WARNING
Keep clear of the saw chain as it will start
rotatIng upon starting of engine.
(2) Fuel
(4) Throttle lever
(6) Latch