LG T2313SSAV Owner's Manual page 37

Symptoms
Filter clogged.
Supply hoses may be kinked.
Washing machine
not filling properly
Insufficient water supply.
Hot and cold supply hoses are
reversed.
Kinked drain hose.
Washing machine
will not drain water
Drain located higher than 1.2 m
above the floor.
Washing machine not unloaded
promptly.
Wrinkling Washing machine overloaded.
Hot and cold water supply
hoses are reversed.
Incomplete or
no dispensing of Too much detergent used.
detergent
Musty or mildewy
Inside of drum was not cleaned
odor in washing
properly.
machine
The load is too small.
Cycle time is longer Heavy articles are mixed with
than usual lighter items.
The load is out of balance.
Reason
• Make sure the inlet filters on the fill
valves are not clogged.
• Check that supply hoses are not kinked
or clogged.
• Make sure that both hot and cold water
taps are turned on all the way.
• Check supply hose connections.
• Ensure that the drain hose is not
kinked.
• Make sure that the drain hose is no
higher than 1.2 m above the bottom of
the washing machine.
• Always remove items from the washing
machine as soon as the cycle is
complete.
• The washing machine can be fully
loaded, but the drum should not be
tightly packed with items. The door
of the washing machine should close
easily.
• Hot water rinse can set wrinkles in
garments. Check the supply hose
connections.
• Follow the guidelines provided by the
detergent manufacturer.
• Run the Tub clean cycle regularly.
• Add more items to allow the washing
machine to balance the loads.
• Always try to wash articles of somewhat
similar weight to allow the washing
machine to evenly distribute the weight
of the load for spinning.
• Manually redistribute the load if articles
have become tangled.
EN
Solution
37