LG T2313SSAV Owner's Manual page 36

Symptoms
Control panel has powered off
due to inactivity.
Washing machine is
unplugged.
Water supply is turned off.
Controls are not set properly.
Door is open.
Circuit breaker/fuse is tripped/
blown.
Washing machine
Control needs to be reset.
will not operate
START/PAUSE was not pressed
after a cycle was set.
Extremely low water pressure.
Washing machine is too cold.
Washing machine is heating
the water or making steam.
36
Reason
• This is normal. Press the POWER
button to turn the washing machine on.
• Make sure cord is plugged securely into
a working outlet.
• Turn both hot and cold taps fully on.
• Make sure the cycle was set correctly,
close the door and press the START/
PAUSE button.
• Close the door and make sure that
nothing is caught under the door
preventing it from closing completely.
• Check house circuit breakers/fuses.
Replace fuses or reset breaker. The
washing machine should be on a
dedicated branch circuit. The washing
machine will resume the cycle where it
stopped once power is restored.
• Press the POWER button, then reselect
the desired cycle and press the START/
PAUSE button.
• Press the POWER button then reselect
the desired cycle and press the START/
PAUSE button. The washing machine
will shut off if theSTART/PAUSE button
is not pressed within 60 minutes.
• Check another tap in the house to
make sure that household water
pressure is adequate.
• If the washing machine has been
exposed to temperatures below
freezing for an extended period of time,
allow it to warm up before pressing the
POWER button.
• The washing machine drum may stop
operating temporarily during certain
cycles, while water is safely heated to a
set temperature.
EN
Solution