The Link Cable; Installing Gdlink And The Drivers - jablotron DAVID GD-04 User Manual

temperature is signalled (e.g. 6°C). Sending an SMS instruction for switching relay X or Y off
puts the heating back to normal mode (with A or B disconnected from GND).
If input A or B is used for thermostat enrollment, the status SMS report (obtained from David
•
on an SMS request) contains information about the temperature.
Example: STATUS:A0,B0,C0,D0,X1,Y0,GSM:70%,TA:25/24C,TB:22/22C
where: TA labels data from thermostat A, TB labels data from thermostat B. The data is of
the form maintained temperature / measured temperature.
Enrolling a thermostat to the A or B input disables relay X or Y enrollments.
•
DIP switch g setting has no effect on enrolled thermostat operation.
•
NOTE: To delete all enrolled items, press and hold buttons XY and ABCD.
11.4. The GD-04P link cable
The GD-04P cable allows you to link David with a PC through an USB port and perform any
desired configuration using GDLink software. The software is supplied on a CD in the package
together with all the necessary drivers. You can also download GDLink from www.jablotron.cz.
11.4.5.

Installing GDLink and the drivers

1. Connect the GD-04P cable to a free USB port on your PC and insert the CD into the CD drive.
2. Wait for "New Hardware Wizard" to start up.
3. Search for the drivers on the removable medium (CD).
4. When installing for WIN XP, ignore the notification about wrong authenticity with WIN XP and
continue with the installation process. Leave the other parameters without any modifications.
5. Finish the new hardware installation wizard process.
6. There are two devices contained in one, so please wait for the "New hardware wizard" to start
again. Repeat the procedure according to steps 3 to 5.
7. Your PC now has two new devices after successful installation - "Jablotron serial interface" as
a serial port (COM) driver and the USB device with the same name as the driver for USB.
8. Install the GDLink software on your PC.
9. Connect the GD-04P cable into David's digital bus connector. GDLink is now ready to be started.
11.4.6.
Using GDLink
The program allows for:
•
o Retrieval and modification of
David settings.
o Displaying
memorized events.
o Relays X and Y direct control.
o Inputs A to D status display.
A comprehensible help option is
•
provided as a part of the program.
GD-04 DAVID
the last 127
9 MKS51202_OS1*