jablotron DAVID GD-04 User Manual page 13

New access code
SMS to get David's status
Service tel. numbers
Optional functions
DTMF code to switch relay
2
ON
DTMF code to switch relay
2
OFF
Wireless device
3
assignments
Triggering re-registration
to the GSM network
Reset
1
Only available for the GD-04A version
2
Only available for the GD-04D version
3
Only available for the GD-04R version
Additional functions
xx...x = new access code, 2 to 8 characters
NPC, xx...x
Example: NPC, MARTIN27
xxx..x = text, up to 30 characters
STS, xx..x
Example: STS, HOW ARE YOU NOW
xxx..x = tel. number. Up to 2 numbers can be
STN, x..x, x..x
set, previously set numbers are erased.
Service numbers are used to report faults:
POWER FAIL / POWER RECOVERY
LINE OK (GSM signal recovery)
Other events – see Optional functions.
Instruction STN, erases service number(s).
Parameter a to f values can be:
DIP,a,b,c,d,e,f,g
1=ON, 0=OFF, x=unchanged
Description of the parameters:
a Forward unrecognised SMSes to the
b Periodic calls to the service number every
c Forward all SMSes to the service number
d Max. 10 SMSes within 15 minutes (all
e SMS reporting of relay dialling-in-control
f SMS reporting of relay SMS control (e.g.
g Input terminal GND connection disables
Example: DIP,1,x,x,x,x,1,x
Use CAY for relay Y.
CAX, xx..x
xx..x = numeric code, up to 8 digits
Example: CAY, 1234
Instruction CAY, erases the code.
Use CDY for relay Y.
CDX, xx..x
xx..x = numeric code, up to 8 digits
Example: CDY, 1234
Instruction CDY, erases the code.
n = A, B, C, D, X or Y (input or output the
LRN,n,xx..x,n,x.
device should be assigned to)
xx..x = device production code (last 8 digits)
Only one device can be assigned to each A
to D input, whereas each of X or Y relays can
have up to 4 devices enrolled.
Example: LRN,A,xx..x,B, xx..x, X,xx..x
Instruction LRN, erases all assignments.
A device cannot have multiple assignments.
The order of A to Y is arbitrary, no
duplications are allowed.
David will unregister and then re-register to the
GSM
GSM network. This can be useful after a blocked
SIM card has been unblocked. A re-registration
is also triggered by briefly connecting the RESET
jumper while David is being powered up.
Resets David to the factory default settings.
RST
This can also be performed by connecting the
RESET jumper during powering up –
disconnect the jumper after approx. 5 sec.
service number
24 hours (from the moment of being set)
subsequent SMS requests ignored)
heating off OK)
any wireless connection to the input (not
applicable to thermostats)
PC
STATUS
none
1
0000000
(all OFF)
none
none
none