Related Manuals for jablotron JA-60GSM
Summary of Contents for jablotron JA-60GSM
- Page 2 1.3. Telephone remote control of the alarm system A Jablotron system equipped with the GSM dialer can be remotely controlled via a landline or mobile phone. From a mobile phone there are two possibilities – either by text instructions sent via SMS or by dialing-in and operating the system via the phone keypad, which operates in the same way as the alarm system keypad.
- Page 3 To switch off the PgX(Y) output, send SMS text: PGOFF Example: to switch the heating on send SMS: AUXON Note: texts of these commands can be customized and protected by a password – see section 3.3. User manual JA-60GSM - 3 - MFJ51808...
- Page 4 (talking or listening) communication from an authorized (stored) phone numbers (see 2.1.). Procedure: From an authorized phone dial the JA-60GSM phone number. The SP-01 will ring once and then it will answer the call...
-
Page 5: User
The setting of reported events for all numbers can be changed – see chapter 3. 2.2. Telephone numbers table Entering Memory To this pair of numbers will be sent (factory default): Telephone numbers sequence 71 ____ F0 - ALARM SMS - Technical SMS 72 ____ F0 User manual JA-60GSM - 5 - MFJ51808... -
Page 6: User
You can make your own setting by: 82 uu t y where: is an event index from 01 to 31 is a telephone number memory from1 to 7 0 = reporting disabled, 1 = reporting enabled User manual JA-60GSM - 6 - MFJ51808... -
Page 7: User
3.2.1. Table – SMS reports assignments to telephone numbers User manual JA-60GSM - 7 - MFJ51808... -
Page 8: Table Of Contents
Alarm system reports: Wireless detector #8 Wireless detector #9 Wireless detector #10 Wireless detector #11 Wireless detector #12 AUXON Wireless detector #13 AUXOFF Wireless detector #14 PGON Wireless detector #15 PGOFF Wireless detector #16 User manual JA-60GSM - 8 - MFJ51808... -
Page 9: See Section
“ *” or ” #“ key. 4.5. Emergency call number setting If the attached telephone is programmed for emergency calls (see section 4.4), it will dial the emergency number after the handset is picked up. User manual JA-60GSM - 9 - MFJ51808... -
Page 10: User
After receiving this command message, the new user code (6789) will be added into the control panel. 4.7. Prepaid SIM cards The JA-60GSM communicator can send information about the credit of a prepaid SIM card. An SMS sent from any of the stored numbers (sequence 7t...) containing the word CREDIT followed by the correct instruction (different for every provider) will result in the sending of the information about the credit. -
Page 11: User
If the user cancels the alarm, all reports, which haven’t been sent yet, will be deleted. This doesn’t included communication with the monitoring station. User manual JA-60GSM - 11 - MFJ51808...
Need help?
Do you have a question about the JA-60GSM and is the answer not in the manual?
Questions and answers