Advertisement
3
Stand a D Shelf on end, and from the BOTTOM
side of the shelf (the bottom side is recessed),
slide the TOP end of a post through a corner hole
until the half-sleeves are seated in the corner hole.
Repeat with remaining posts.
5
Snap half-sleeve sets onto all four posts at the
desired height for the NEXT shelf. Lower this shelf
into position and press until fully seated. Install the
third and fourth shelves in the same manner, with
both shelves mounted ABOVE the post seams.
5276-37: 2 of 2; Rev. 1;
06/09
Limited One-Year Warranty against defects in material and workmanship.
Safco Consumer Hot Line 1-800-664-0042
Safco Products Company, New Hope, MN 55428
4
Set the unit upright. Press the shelf firmly at each
shelf corner, close to the corner holes, until firmly
seated.
D
6
Set the unit into place and adjust the
levelers at the bottoms of the posts until
shelves are level in both directions.
HALF-
SLEEVES
POST
SEAM
SHELF
MODEL 5276
(SHOWN ASSEMBLED)
Advertisement
