Replacing The Fuse - Yamaha M-Slaz TFX150 Owner's Manual

NOTICE
To charge a VRLA (Valve Regulated
Lead Acid) battery, a special (con-
stant-voltage) battery charger is re-
quired. Using a conventional battery
charger will damage the battery.
To store the battery
1. If the vehicle will not be used for
more than one month, remove the
battery, fully charge it, and then
place it in a cool, dry place.
NOTICE: When removing the
battery, be sure the key is
turned to "OFF", then discon-
nect the negative lead before
disconnecting the positive lead.
[ECA16303]
2. If the battery will be stored for
more than two months, check it at
least once a month and fully
charge it if necessary.
3. Fully charge the battery before in-
stallation. NOTICE: When install-
ing the battery, be sure the key
is turned to "OFF", then connect
the positive lead before con-
necting the negative lead.
Periodic maintenance and adjustment
ECA16522 4. After installation, make sure that
the battery leads are properly con-
nected to the battery terminals.
NOTICE
Always keep the battery charged.
Storing a discharged battery can
cause permanent battery damage.
[ECA16841]

Replacing the fuse

The fuse box is located under the rider
seat. (See page 4-12.)
ECA16531
ZAUE0604
1. Fuse
If the fuse is blown, replace it as fol-
lows.
1. Turn the key to "OFF" and turn off
2. Remove the rider seat. (See page
3. Remove the blown fuse, and then
7-30
1
all electrical circuits.
4-12.)
install a new fuse of the specified
amperage. WARNING! Do not
use a fuse of a higher amperage
rating than recommended to
avoid causing extensive dam-
age to the electrical system and
possibly a fire.
[EWA15132]
EAUE1423
7