Hitron CODA-4*8 Series DOCSIS User Manual page 72

Table 17: The Basic: Port Forwarding Add/Edit Screen
Protocol
Public Port Range
Private Port Range
Local IP Address
Remote IP Address
Rule Status
Apply
Close
72 72
Version 1.0, 11/2016. Copyright
Version 1.0, 11/2016. Copyright
Hitron CODA-4x8x User's Guide
Use this field to specify whether the CODA-4x8x should
forward traffic via:
Transmission Control Protocol (TCP)

User Datagram Protocol (UDP)

Transmission Control Protocol and User Datagram

Protocol (TCP/UDP)
Generic Routing Encapsulation (GRE)

Encapsulating Security Protocol (ESP)

NOTE: If in doubt, leave this field at its default (TCP/
UDP).
Use these fields to specify the incoming port range.
These are the ports on which the CODA-4x8x receives
traffic from the originating host on the WAN.
Enter the start port number in the first field, and the end
port number in the second field.
To specify only a single port, enter its number in both
fields.
Use these fields to specify the ports to which the
received traffic should be forwarded.
Enter the start port number in the first field. The number
of ports must match that specified in the Public Port
Range, so the CODA-4x8x completes the second field
automatically.
Use this field to enter the IP address of the computer on
the LAN to which you want to forward the traffic.
Use this field to enter the IP address of the computer on
the WAN from which you want to forward the traffic.
Select ON to enable this rule, or select OFF to disable it.
Click this to save your changes to the fields in this
screen.
Click this to return to the Port Forwarding screen
without saving your changes to the rule.
2012 Hitron Technologies
2016 Hitron Technologies