Wi-Fi Power Cycle; Flea Power Release - Dell G5 15 Service Manual

Table 16. Diagnostics
Light pattern
2,1
2,2
2,3
2,4
2,5
2,6
2,7
3,1
3,2
3,3
3,4
3,5
3,6
3,7
Camera status light: Indicates whether the camera is in use.
• Solid white — Camera is in use.
• Off — Camera is not in use.
Caps Lock status light: Indicates whether Caps Lock is enabled or disabled.
• Solid white — Caps Lock enabled.
• Off — Caps Lock disabled.

Wi-Fi power cycle

If your computer is unable to access the internet due to Wi-Fi connectivity issues a Wi-Fi power cycle procedure may be performed. The
following procedure provides the instructions on how to conduct a Wi-Fi power cycle:
NOTE: Some ISPs (Internet Service Providers) provide a modem/router combo device.
1 Turn off your computer.
2 Turn off the modem.
3 Turn off the wireless router.
4 Wait for 30 seconds.
5 Turn on the wireless router.
6 Turn on the modem.
7 Turn on your computer.

Flea power release

Flea power is the residual static electricity that remains on the computer even after it has been powered off and the battery has been
removed. The following procedure provides the instructions on how to conduct flea power release:
1 Turn off your computer.
2 Remove the base cover.
110 Troubleshooting
Problem description
CPU failure
System board: BIOS and ROM failure
No memory or RAM detected
Memory or RAM failure
Invalid memory installed
System board or chipset error
LCD failure
CMOS battery failure
PCI or video card or chip failure
Recovery image not found
Recovery image found but invalid
Power sequencing failure
Flash corruption detected by SBIOS
ME error