Advertisement
COMPLETE AUDIO CONTROLLER/AMPLIFIER SYSTEM
[Complete Programming Instructions can be found in the Installation Instruction Manual]
PROGRAMMING KEYPAD BUTTONS (SINGLE COMMANDS)
Note: When learning IR commands into the BXAUDIO4X4 Controller, make sure the IR Learning eye is free from IR
interference that might result in IR learning error or intermittent IR commands. IR Interference could be caused by any
of the following: Sunlight, Fluorescent light, LCD or Plasma displays, Computer Monitors, EMI etc..
1. Make sure an LCKP4 Keypad is plugged into the Zone 1 Keypad port and the Keypad is ON [32].
2. Power BXAUDIO4X4 Controller ON.
3. Place Unit in RUN MODE (Switch [10] in "DOWN" position).
4. Make sure Keypad is powered ON.
5. Press the SOURCE BUTTON on the LC4KP Keypad for the device to be programmed (Buttons [35 thru 38]).
Note: SOURCE BUTTONS can only be selected when unit is in RUN MODE and not in PROGRAM MODE..
6. Enable PROGRAM MODE (Set Mode Switch [10] in the 'UP' position).
7. Press the PROGRAM KEYPAD [2] button on the front of the BXAUDIO4X4.
a. Confirm the PROGRAM KEYPAD LED [11] is illuminated GREEN.
8. Press the BUTTON on the LC4KP KEYPAD to be programmed
a. Confirm the STATUS LED [14] is illuminated GREEN
9. Aim the Manufactures Source Remote at the IR Learning eye on the front of the BXAUDIO4X4 [5].
10. Press and Release the corresponding button on the devices remote (make sure to use a short, quick press of the
devices remote when learning commands).
11. If the code was learned correctly the STATUS LED will turn OFF and the PROGRAM KEYPAD LED will remain
GREEN. (To program a Sequence of commands under this button, proceed to step 2 in the following section).
Note: If the code is learned incorrectly, the PROGAM LED will blink RED three times. In this case, repeat steps 4
through 7.
12. Repeat steps 4 through 7 for all of the desired IR commands for Source #1.
QUICK PROGRAMMING GUIDE
MODEL BXAUDIO4X4
FOUR ZONE – FOUR SOURCE
Programming Button Layout
30
34
36
37
32
33
35
42
43
44
31
38
39
40
41
42
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Xantech BXAUDIO4X4
Summary of Contents for Xantech BXAUDIO4X4
- Page 1 PROGRAMMING KEYPAD BUTTONS (SINGLE COMMANDS) Note: When learning IR commands into the BXAUDIO4X4 Controller, make sure the IR Learning eye is free from IR interference that might result in IR learning error or intermittent IR commands. IR Interference could be caused by any of the following: Sunlight, Fluorescent light, LCD or Plasma displays, Computer Monitors, EMI etc..
- Page 2 The STATUS LED [14] should turn GREEN 8. Aim the Manufactures Source Remote at the IR Learning eye on the front of the BXAUDIO4X4 and press and release the corresponding button on the devices remote to record the second toggle command.
Need help?
Do you have a question about the BXAUDIO4X4 and is the answer not in the manual?
Questions and answers