Page 1
MX88vi, MX88ai Multi-room IP Interface INTRODUCTION The MX88vi and MX88ai have the capability to connect to an internet-ready device such as the popular Apple iPad and/or a personal computer. A web-based user interface provides control to the MX88vi and MX88ai. It is recommended to use a web-browser (such as Apple Safari and Mozilla Firefox) with a screen resolution of 800 x 600 or greater.
Page 2
CONNECTIONS The MX88vi and MX88ai must be connected to a network. A wireless Ethernet router is preferred so that a wireless tablet, such as the Apple iPad can be used. While a personal computer is not a necessity for the installation, it is good idea to connect it to the Ethernet router for the initial network configuration.
NETWORK CONFIGURATION OVERVIEW Note: Most residential networks are managed by a network router (usually the box next to the cable or DSL modem). You will need to have access to the network router settings in order to successfully add the MRIP to the network. In order to fully enjoy the MRIP, you will need to configure it with a “static”...
The MRIP Installer application is included with Universal Dragon (version 2.3.38.0 or higher). You can find it in the “MRIP Config Tool” folder in your Dragon installation folder. This will usually be: C:\Program Files\Xantech\Universal Dragon v2.3\MRIP Config Tool If you are running on Windows 7 64-bit, then this folder will be: C:\Program Files(x86)\Xantech\Universal Dragon v2.3\MRIP Config Tool...
Figure 4: MRIP Installer Utility – IP Setup In the IP field, enter in the desired static IP Address. If you do not know a good static IP Address, please consult ‘HOW TO PICK A STATIC IP ADDRESS’ on Page 3 of this instruction guide. In the Network Mask field, enter in the value: 255.255.255.0 Leave the other two fields at 0.0.0.0.