Page 1
A/B Speaker Selector, A/B Source Selector DESCRIPTION The XSSD2100W provides an easy-to-use, easy-to-install, A/B or A+B speaker selector switch. It is also a A/B source selector switch. Premium components are used to provide high-quality speaker or amplifier selection. The XSSD2100W requires no external power source. The XSSD2100W cannot be used with high power bridged amplifiers.
Page 2
The figure above shows the XSSD2100W in an application with two sources and two pairs of speakers. 08905088B - 2 -...
Page 3
INSTRUCTIONS (With Volume Control) 1) Remove ¼” of insulation from the ends of the wires. 2) Connect the following wires together: VOLUME CONTROL INPUT Right + Right – Left – Left + 3) Connect the two sources according to the chart below: Source “1”...
Page 4
The figure above shows the XSSD2100W in an application with two sources and two pairs of speakers. A Xantech XVC volume control is also used to create an enhanced system. 08905088B - 4 -...
Page 5
The figure above shows the XSSD2100W, rear view. 08905088B - 5 -...
Page 6
Covered product must be sent to Xantech together with proof of purchase, RA number, prepaid and insured to Xantech. Freight collect shipments will be refused. Risk of loss or damage in transit is borne by the sender.