Table of Contents
Advertisement
16
AIR FILTER
Level 1.
Tools required: 25 or 50 mm (1 or 2 in.) medium bristle paint brush
Parts required: 90008 REPOWER
1. Close choke (Cold Start Position). This prevents dirt from entering
the carburetor throat when the air filter is removed. Brush accumu-
lated dirt from the air cleaner area.
2. Remove the air cleaner cover. Clean and inspect the element for
damage. If element is fuel soaked and very dirty, replace.
3. If element can be cleaned and reused, be certain it:
• properly fits the cavity in the air cleaner cover.
• is installed with the original side out.
NOTE
Carburetor adjustment may be needed after air filter cleaning/
replacement. See Carburetor Adjustment Section.
FUEL FILTER
Level 1.
Tools required: 200-250 mm ( 8-10 in.) length of wire with one end
bent into a hook. Clean rag, funnel, and an approved
fuel container
Parts required: 90008 REPOWER
WARNING
Fuel is VERY flammable. Use extreme care when mixing, storing or
handling or serious personal injury may result.
1. Use a clean rag to remove loose dirt from around fuel cap and empty
fuel tank.
2. Use the "fuel line hook" to pull the fuel line and filter from the tank.
3. Remove the filter from the line and install the new filter.
TM
Air & Fuel Filter Kit
TM
Air & Fuel Filter Kit
DANGER
Advertisement
Table of Contents
