Honda HP500H Owner's Manual page 51

327766300.book 48 ページ ２０１２年５月１５日 火曜日 午前１１時１７分
6.Remove the sprocket.
7.Place the track over the driven wheel, and engage the sprocket with
the track teeth.
8.Push the sprocket and track toward the rear, then slide the sprocket
onto the sprocket shaft.
9.Install and tighten the sprocket bolts securely.
DRIVEN WHEEL
TRACK
10.Remove the wooden blocks and make sure the power carrier is level.
Then adjust the track tautness.
CAUTION:
• Special care should be exercised when mounting the tracks.
• Do not tip the carrier onto its side; oil and gasoline may spill out.
• After following the above temporary procedure, have the power 
carrier inspected by your authorized Honda dealer as soon as 
possible.
48
SPROCKET
DRIVEN WHEEL
SPROCKET BOLT
SHAFT