Setup And Adjustments - Olivetti PR4 SLIP Service Manual

4. SETUP AND ADJUSTMENTS

Proceed as follows to setup and/or adjust the printer:
a. Open the printer's front cover.
b. Press keys 1 and 2 simultaneously until an acoustic
signal is sounded.
c. Press keys 1 and 2 simultaneously again, until
another acoustic signal is sounded.
d. Close the printer's top cover.
Ref. Ref. Ref. LED Indications on the Console LED Indications on the Console LED Indications on the Console
Ref. Ref. LED Indications on the Console LED Indications on the Console
1 1 1 1 1
2 2 2 2 2
3 3 3 3 3
4 4 4 4 4
5 5 5 5 5
6 6 6 6 6
7 7 7 7 7
XYAA6338
An acoustic signal sounds and the three LEDs located on
the lower part of the control console light to indicate
when the printer switches to the initial status menu.
Pressing key 1 one or more times provides you with a
light indication corresponding to the operation to be
performed (refer to the table below that provides the
correspondence between the light indications and the
operations to be performed). Pressing key 2 grants
access to the menu indicated by the LED combinations.
Setup/Adjustment Operation Set Setup/Adjustment Operation Set Setup/Adjustment Operation Set
Setup/Adjustment Operation Set Setup/Adjustment Operation Set
Initial state (Setup/adjustment mode)
Operator test
Printer setup
Entrance into the Adjustment Menu
Hexdump
Auto read Micr
Slip test
Service Manual 4-1