Deleting Fingerprints; Hot Keys; Tamper Detection; Stealth Mode - Vaultek VT20i Instruction Manual

Deleting Fingerprints

Individual fingerprints can not be deleted from the keypad on the safe. Following this procedure will erase all of
the fingerprints including both administrative fingerprints. If you wish to delete individual fingerprints, you must
use the Vaultek™ app. This procedure will not affect the keypad master code.
1
Press and hold '3' and '5' until all the keys (1-5) light up RED and let go.
2 Enter your master code on the keypad. If the code is correct, all the numbers on the keypad will blink GREEN
during deleting; then the light above the fingerprint sensor will turn solid GREEN and safe will beep indicating
deletion of all of the fingerprints.

Hot Keys

11 Vaultek™ VT20i

Tamper Detection

Press and hold '2' and '4'

Stealth Mode

Press and hold '1' and '3'

Travel Mode

Press and hold '1', '3'
and '5'
To check for tampering press and hold keys '2' and '4'
at the same time for 3 seconds. The '3' key will glow RED
to indicate tampering or GREEN to indicate no tampering.
You can reset the tamper detection by entering the
master code on the keypad.
To toggle the sound ON/OFF press and hold keys
'1' and '3' at the same time for 3 seconds. If button '2'
glows GREEN, the sound is ON; if button '2' glows RED,
the sound is OFF.
Save battery life by disabling the proximity sensor,
fingerprint sensor, keypad, and Bluetooth features. To
toggle travel mode ON/OFF press and hold keys '1', '3',
and '5' at the same time until safe beeps.