Programming 1St And 2Nd Fingerprints - Vaultek VT20i Instruction Manual

Programming the 1st and 2nd Fingerprints
The 1st and 2nd fingerprints will be recognized as administrative fingerprints and will be used to authorize
additional users.
1 Open the safe. Program 1st fingerprint by quickly pressing and releasing the "PROGRAM" button (Figure I). The
light above the fingerprint scanner (Figure J) will be RED and the '1' button on the keypad will blink RED.
2 Using the helpful programming tips provided on page 08 place your finger on the fingerprint sensor for the first
of 5 scans. When the safe beeps and the '1' button flashes GREEN and then solid RED remove your finger. If the
sensor turns red remove your finger and try again.
3 Place finger again over the scanner until the safe beeps and the number 2 lights up GREEN and lift. You will
repeat this process until all keys (1-5) are solid GREEN.
4
Close lid and test to see if the safe will open using your fingerprint. If you experience issues refer to the helpful
programming tips listed on page 08.
5 Repeat steps 1 through 4 to add the 2nd administrative fingerprint.
FIGURE I
09 Vaultek™ VT20i
PROGRAM
FIGURE J