Processor Heat Sink - Dell Studio XPS 1340 Service Manual

Back to Contents Page
Processor Heat Sink
Dell™ Studio XPS™ 1340 Service Manual
Central Processor Heat Sink
Graphic Processor Heat Sink/Thermal Fan
CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface
(such as a connector on the back of the computer).
NOTICE: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ is
not covered by your warranty.
NOTICE: To help prevent damage to the system board, remove the main battery (see
inside the computer.
Central Processor Heat Sink
Removing the Central Processor Heat Sink
1. Follow the instructions in Before You
2. Remove the base cover (see
3. Remove the rear caps (see
4. Loosen the four captive screws that secure the central processor heat sink to the system board.
1 captive screws (4)
5. Lift the central processor heat sink off the computer.
Replacing the Central Processor Heat Sink
NOTE: This procedure assumes that you have already removed the central processor heat sink and are ready to replace it.
1. Place the new thermal cooling pad on the central processor heat sink.
NOTE: If the central processor heat sink is replaced, the thermal cooling pad will be attached to the new central processor heat sink.
2. Place the central processor heat sink on the system board.
Begin.
Removing the Base Cover).
Removing the Rear Caps).
2 central processor heat sink
Before Working Inside Your Computer) before working