Sony SAL50F14 Service Manual page 17

2. Apply the grease (G-35) to the instruction part of the inner helicoid barrel.
3. Apply the adhesive bond (B-40) to the hold screw, and tighten it to the outer tube.
4. Apply the grease (G-35) to the instruction part of the outside barrel.
5. Assemble the outside barrel, inner helicoid barrel, and inner barrel, and check the operation of the helicoid (stiffness, smoothness,
catching).
6. Set the helicoid level as shown in the figure.
Note:
This level is infinity position.
22.1 mm
HELP13
Adhesive bond (B-10): J-6082-612-A
After the focus brush position adjustment is completed, apply the adhesive bond (B-10) as shown in the figure.
SAL50F14 (1.4/50) (50mm F1.4)
Apply the grease (G-35)
(All circumference of threaded portion)
Apply the grease (G-35)
(All circumference of threaded portion)
Apply the adhesive bond (B-40)
Outside Barrel
16.1 mm
Inner Helicoid Barrel
Inner Barrel
Apply the adhesive bond (B-10)
Focus Brush
HELP