Table of Contents
Advertisement
Tip
To turn off all the RCA, GE, and PROSCAN components
that are connected to the TV, press ON•OFF twice
within two seconds.
This feature only works with most RCA, GE, and
PROSCAN products.
Chapter 2
Using the Remote Control
MUTE Reduces the TV's volume to its minimum level. Press again to
restore the volume.
OK When in the menu system, selects highlighted items.
ON•OFF When in TV mode, turns the TV on and off. If in another
device mode (VCR, DVD, SAT•CABLE, etc.) and programmed, will turn
the device on and off.
PIP Brings up the small picture-in-picture window. Press again to
remove the PIP window. (See Chapter 3 for more information about
using PIP.)
REVERSE, PLAY, FORWARD, REC•VCR+, STOP, PAUSE If
programmed, provides transport control for some remote-controllable
VCRs, DVD players, laserdisc players, tape decks, and CD players.
Pressing REC•VCR+ when using the GUIDE Plus+ System sets the VCR
to record a program.
SAT•CABLE Puts the remote in SAT•CABLE mode and, if Autotuning is
enabled, will turn on the TV and tune to the correct input channel.
SKIP Press once before changing channels and the TV will wait 30
seconds before returning you to the original channel. Press repeatedly to
add more time. Also, activates Search function for some GE, RCA, or
PROSCAN VCRs.
SWAP When using PIP, swaps the main picture with the PIP window.
TV Turns on the TV and puts the remote in TV mode. Also displays
channel information.
VCR1 Puts the remote in VCR1 mode and, if Autotuning is enabled,
will turn on the TV and tune to the correct input channel.
VCR2 Puts the remote in VCR2 mode and, if Autotuning is enabled,
will turn on the TV and tune to the correct input channel.
VOL – or VOL + Decreases or increases the TV's volume.
WHO In SAT mode, press to select available channel lists "profiles"
(RCA, GE, and PROSCAN satellite or HD receivers only). This button
does not operate in the TV mode.
Using the INPUT Button
Use the INPUT button to scroll through the available input channels and
view components you have connected to the TV.
1. Press TV to place the remote in TV mode. Make sure the
component you want to view is turned ON.
2. Press INPUT to tune to an available input channel.
3. To return to the channel you were previously watching, press
the INPUT button until you see the channel in the upper right
corner.
27
Advertisement
Table of Contents
