Camstack - Singer 5400 Series Service Manual

Service Manual
Removal:
1-
Remove the free arm extension table, tension assembly dial, the knobs of the zig-zag and needle
position levers and all covers (face plate, rear, bottom bed and front)
2- Remove three screws (A).
3- Set stitch length control dial to "5" and move the zig-zag lever to left (Straight stitch position)
4- Remove camstack assembly (B).
Replacement:
1-
Replacement is the same as removal in reverse order.
2- Adjust camstack radial play and needle bar pendulum timing. (See pages 58 to 59 and 66-67)
3- Check left-to-right needle location and zig-zag bight stops and adjust if necessary. (See pages 70-7
and 76 to 79)
4- Check needle follower clearance. (See pages 58 to 59)
Rev. n .
o
MAY/00

Camstack

24
1
P/N 357773-002