Panasonic NC-TWS30 Service Manual page 6

NC-TWS30
2.3. Thermal fuse comp. and
Thermostat
1. Remove 2 screws of Cover plate.
2. Remove white and black Lead wires of
Heater terminal.
3. Remove Cover plate from Container.
4. Remove Thermal fuse comp. from Cover plate.
5. Remove Hold spring A from Cover plate.
6. Rotate Thermostat 90° to remove it.
Operating point
- Careful Thermostat leans when assemble with Cover
plate.
- Do not forget to put Compound.
- Remove white and black Lead wires with wrench.
2.4. Case A Comp.
1. Remove Water pipe comp. and then remove Case A
comp..
2. Pull off Ball A from Case A comp..
Tapping screw (M4 x 8)
Heater
terminal
Thermostat
Hold spring A
Water pipe
comp.
Ball A
Case A
comp.
- 6 -
Thermal fuse
comp.
Container comp.
Cover plate
Fig. 3
Lead wire assy E
Fig. 4