Magellan ToughCase Instruction Booklet page 6

Setting the ToughCase Power Mode
The ToughCase GPS receiver has four power
modes available; OFF/ON (described above),
idle, battery only, or battery+GPS.
Pressing the Mode button (on the bottom of
the ToughCase GPS receiver) causes the LEDs
to display the current mode the ToughCase
GPS receiver is in. To change the mode you
need to press the Mode switch again before
the LEDs go out. (When powering on, all
lights flash momentarily.)
Mode - LED Indicators
Battery Only
Battery and GPS
Powering Down
Charging the ToughCase GPS
Receiver
To charge the ToughCase GPS receiver,
simply connect the USB cable from the
ToughCase to your IBM-compatible or
Macintosh computer. Alternatively, you can
charge the ToughCase with an AC adapter
(like the one supplied with your iPhone).
ToughCase Battery Life
When your iPhone or iPod touch is installed
in the ToughCase GPS receiver and the power
mode is set to Battery only or Battery+GPS,
the battery in the ToughCase GPS receiver
will charge your iPhone or iPod touch.
The ToughCase GPS receiver charges when it
is connected to a PC with the USB cable
(supplied) or a USB power adapter.
6 en