Lexus NX300h Owner's Manual page 230

230
8-1. Phone operation (Hands-free system for cellular phones)
out" is set to on, messages will be
automatically read out. (→P.240)
Select to call the message sender.
D
• Depending on the type of Bluetooth
phone being connected, this function
cannot be used.
● Depending on the type of Bluetooth
phone being connected, it may be neces-
sary to perform additional steps on the
phone.
Messages are displayed in the appropri-
●
ate connected Bluetooth
tered mail address folder. Select the
desired folder to be displayed.
● Only received messages on the con-
nected Bluetooth
played.
The text of the message is not displayed
●
while driving.
● Turn the "PWR·VOL" knob, or use the
volume control switch on the steering
wheel to adjust the message read out vol-
ume.
● "Subject:" field is not shown on SMS case.
Replying to a message (dictation
reply)
1
Select "Reply".
2 Select "Dictation".
3 When the "Say Your Message"
screen is displayed, speak mes-
sage that you want to send.
4
Select "Send" to send message.
"Cancel": Select to cancel sending the
message.
"Retry": Select to retry speaking message
that you want to send.
 While the message is being sent, a
sending message screen is dis-
played.
LEXUS NX300h/NX300
al_USA_OM78229U
®
®
®
phone's regis-
®
phone can be dis-
Navi Manu-
5
Check that a confirmation screen is
displayed when the operation is
complete.
 If an error message is displayed, fol-
low the guidance on the screen to
try again.
Replying to a message (quick
reply)
15 messages have already been stored.
1
Select "Reply".
2
Select "Quick Message".
3
Select the desired message.
4 Select "Send".
"Cancel": Select to cancel sending the
message.
 While the message is being sent, a
sending message screen is dis-
played.
5
Check that a confirmation screen is
displayed when the operation is
complete.
 If an error message is displayed, fol-
low the guidance on the screen to
try again.
Editing quick reply messages
■
This operation cannot be performed
while driving.
1 Select "Reply".
2
Select corresponding to the
desired message to edit.
3
Select "OK" when editing is com-
pleted.
To reset the edited quick reply messages,
●
select "Default".