Table of Contents
Advertisement
About this task
You can remove a cooling fan module without shutting down the expansion enclosure. However, the expansion enclosure must have
at least two cooling fan modules installed while the expansion enclosure is powered up. Do not remove more than one cooling fan
module while AC power is on.
CAUTION:
A cooling fan module must be replaced within five minutes of extending the expansion enclosure from the rack. Do not remove
a faulted fan unless a replacement is on hand and available to be installed within five minutes.
Steps
1.
Remove the front bezel.
2.
Extend the expansion enclosure chassis from the front of the rack.
3.
Unlock the fan module by pushing the orange tab to the left.
4.
Pull up on the latch handle to release the fan module.
5.
Pull the fan module up and out of the chassis.
Figure 39. Removing a Cooling Fan Module
Install a Cooling Fan Module
Use this procedure to install a cooling fan module.
About this task
The expansion enclosure must have at least two cooling fan modules installed while the expansion enclosure is powered up. Do not
remove more than one cooling fan module while AC power is on.
CAUTION:
A cooling fan module must be replaced within five minutes of extending the expansion enclosure from the rack. Do not remove
a faulted fan unless a replacement is on hand and available to be installed within five minutes.
Steps
1.
Align the cooling fan with the guides in the empty slot.
2.
Gently lower the cooling fan into the empty slot.
3.
Push the latch down into the closed position.
40
Replacing SCv360 Expansion Enclosure Components
Advertisement
Table of Contents
