Traktor 3 Le Controller Mapping - Numark STEALTH CONTROL Quick Start Manual

TRAKTOR 3 LE CONTROLLER MAPPING

24
3
25
11
26
12
27
9
13
5
1. TRACK - You can use the TRACK knob to scroll
through the music on your computer. Press down
on the TRACK knob to load the selected track in
the preview player.
pressing and holding down the PAGE button to
browse and navigate through your different drives,
folders and playlists. Once you release the PAGE
button, you can then use the TRACK knob to
browse the contents of the selected folder.
2. PAGE - Holding down the PAGE button while
using certain controls on the Stealth Control allows
for an additional layer of functionality.
3. CUE SOURCE - Press the CUE SOURCE button
to send the music playing on the deck to the
Monitor channel. Please note that if you are not
using a multiple output audio interface, the Monitor
(headphone) channel will be the same as the
Master channel.
structure on the left of the screen, while holding
down the PAGE button, you can use the CUE
SOURCE buttons to expand and collapse the
selected folder. The left CUE SOURCE button will
collapse the selected folder, while the right CUE
SOURCE button will expand the selected folder.
4. PLAY - Press the PLAY button to begin playing
the track.
5. CUE - The CUE button will return and pause the
22
15
23
16
28
16
29
16
10
17
14 7
8
6 4
Use the TRACK knob while
When browsing the folder
22
15
19
23
16
21
32
16
33
20
16
1
17
14
2
8
18 5
track at the last set cue point. For temporary
play of the cue point, you can hold down the
CUE button. The track will play for as long as
the button is held down and will return to the
cue point once it has been released.
6. SET CUE - You can use this button to set a
new cue point.
7. CUE PLAY - You can hold down the CUE
PLAY button to go back and pause at the last
set cue point.
PLAY button, the track will begin playing.
8. VOLUME - Each virtual deck features a
VOLUME fader which can be used to make
volume adjustments to the music playing on
the corresponding deck.
9. PITCH - Each virtual deck features a PITCH
SLIDER, which can be used to change the
pitch or tempo of the music playing on the
corresponding deck.
10. PITCH BEND -/+ - You can use these two pitch
bend buttons to temporarily adjust the pitch
and tempo of the music playing on the
corresponding deck.
used to make small adjustments when mixing
two tracks so their beats occur synchronously.
3
30
3
31
11
34
12
35
9
10
7
13
6 4
When you release the CUE
Pitch bend is typically