Cactus V5 Duo User Manual page 12

12
7.3
batteries are installed in the correct
polarity.
2. Set the V5 transceivers to the correct
mode (Transmitter to "TX" , Receiver to
"RX") . This will automatically power on
the transceivers.
3. Connect RX to your camera using an
appropriate shutter release cable.
4. Set both TX and RX to the same channel
using the Channel Dial. Ensure the
channel set on the wireless shutter
release transceivers is different from
that set on the wireless flash
transceivers (if any) .
5. Half press the Test button on TX to auto
focus. The status LED on both TX and RX
will turn ORANGE to indicate auto focus.
6. Full press the Test button on TX for
shutter release. The status LED on both
transceivers will turn GREEN to indicate
shutter release.
As Wireless Shutter Release in Bulb Mode
(requires optional shutter release cable)
1. Setup V5 transceivers as Wireless
Shutter Release.
2. Full press and hold the Test button on