Remote Inputs 1 To 8 Connections - Ecler essentials eMIMO1616 User Manual

5.6. REMOTE INPUTS 1 to 8 connections

On the eMIMO1616 rear panel there are 8 control ports, REMOTE INPUTS 1 to 8,
which are enabled for the connection of eMCONTROL1 zone control wall panels.
Each port has an RJ45 connector, and each eMCONTROL1 panel also has an RJ45
connector, such that the physical connection between a remote panel and a
REMOTE port on the eMIMO1616 unit can be made, point to point, via a CAT5
standard or higher (crossover) cable.
This physical connection provides a DC power supply to the remote panel from the
eMIMO1616 unit, and establishes a digital communication bus between the two
pieces of equipment. It also allows the reception of balanced mono audio from a
potential remote sound source (connected on the side of the control panel) on the
eMIMO1616 unit.
The wall control panels are configured by the Administrator user via the
eMIMO1616 web application(see web application manual for the eMIMO1616), so
that it is possible to fully disable them, or enable them to function as user controls
for an installation zone, including all or some of the following functions:
 Selection of sound source (program audio), from a customised list for each
panel that includes some local sources and/or the remote source itself.
 Volume adjustment (with a maximum and minimum adjustment margin)
and mute control
 Equalisation adjustment, with 3-band EQ (BASS-MID-TREBLE).
Alternatively, these inputs may receive, exclusively, a balanced mono signal via the
RJ45 connector, while respecting the corresponding assignation of pins (see
section 3.4):
 Hot or direct signal
 Cold or inverted signal
 Earth
> Terminal 8 on the RJ45 connector
> Terminal 7 on the RJ45 connector
> Terminal 6 on the RJ45 connector
15