Configuration; Service And Maintenance - ABB B23 Installation Manual

EN

Configuration

To configure the meter and change the default settings, follow the in-
structions in the Configuration Guide at the end of this manual.
Default Settings
The following table lists the default settings of the meter that normally
needs to be changed. Check the settings to see if any of them needs to
be changed.
N
Note – For all other settings, including communication default
settings, refer to the B23/B24 User Manual.
Parameter
Ratios CT
Pulse frequency
Pulse length
No. of wires

Service and Maintenance

The meter contains no parts that can be repaired or exchanged. A bro-
ken meter must be replaced.
If the meter needs to be cleaned, use a lightly moistened cloth and a
mild detergent to wipe it.
C
Caution – Be careful that no liquid gets into the meter since it
may damage the equipment.
Direct connected
----
100 imp/kWh
100 ms
4
9
Transformer conn.
1
10 imp/kWh
100 ms
4
EN